A practical reference on Enkephalinase: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-01-20. Anything still debated is marked as such rather than presented as settled.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
Identity and purity of selank are established with reversed-phase high-performance liquid chromatography coupled to mass spectrometry. The peptide elutes from C18 columns with acetonitrile gradients in water containing trifluoroacetic acid or formic acid, and detection is usually performed by ultraviolet absorbance near 214 nm. Electrospray ionization in positive mode gives a doubly protonated ion near m/z 377, consistent with a mass of about 752 Da. Amino acid analysis or tandem mass spectrometry of fragment ions confirms the sequence. Because the molecule has no aromatic residues, it lacks a usable 280 nm chromophore, so low-wavelength detection or mass spectrometry is required.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
| Property | Value | Notes |
|---|---|---|
| Identity confirmation | Reversed-phase HPLC retention time versus reference standard | Retention depends on column, gradient, and ion-pairing agent |
| Mass confirmation | Electrospray or MALDI mass spectrometry | Doubly protonated ion near m/z 377 is consistent with about 752 Da |
| Typical purity specification | 95 percent or higher by chromatographic peak area | Lower values suggest truncated or modified peptide species |
| Storage of lyophilized powder | -20 °C, desiccated, protected from light | Powder tolerates long storage better than solution |
| Storage of solution | 2-8 °C for short periods | Freeze-thaw cycling promotes aggregation and surface adsorption |
Selank is a synthetic heptapeptide developed in Russia. Its sequence is Thr-Lys-Pro-Arg-Pro-Gly-Pro, a seven-residue chain built around the natural tetrapeptide tuftsin. Researchers at the Institute of Molecular Genetics of the Russian Academy of Sciences first described the compound in the mid-1990s. The design combined the tuftsin core with an added Pro-Gly-Pro tail, a modification intended to extend the molecule's stability in biological fluids. Published work on the peptide has appeared mainly in Russian-language journals.
Reported activity for Selank centers on anxiolytic and nootropic effects. Russian clinical reports describe use in anxiety and in cognitive or attention-related complaints. Most of this evidence comes from studies conducted by the same research groups that developed the peptide. Independent replication in other countries remains limited, and no major Western regulatory agency has approved the compound for any indication. The gap between local reports and external verification is a recurring point in discussions of the peptide.
Tuftsin, the parent structure, is a naturally occurring immunomodulatory tetrapeptide released from the Fc region of immunoglobulin G by spleen enzymes. Selank extends this four-residue sequence with three additional amino acids. The stated rationale is that the added tail slows enzymatic breakdown and may influence receptor interactions. How the full heptapeptide behaves at the molecular level is not firmly established, and proposed mechanisms often involve indirect modulation of neurotransmitter or immune signaling rather than a single defined target.
Selank is a synthetic heptapeptide developed in Russia as a structural analogue of tuftsin, a naturally occurring immunomodulatory tetrapeptide. Its sequence, Thr-Lys-Pro-Arg-Pro-Gly-Pro, keeps the tuftsin core at the N-terminus and appends a Pro-Gly-Pro tail. Researchers at the Institute of Molecular Genetics in Moscow synthesized the compound during the 1990s while searching for peptides with combined anxiolytic and immunomodulatory activity. The added tail was intended to resist enzymatic cleavage and prolong the molecule's presence in circulation.
The compound has a calculated molecular weight near 751.9 daltons and carries a net positive charge at physiological pH because of its arginine residue. It dissolves freely in water and in common aqueous buffers, and typically appears as a white or off-white lyophilized powder. The amide backbone makes the molecule susceptible to peptidases, which limits oral use and favors intranasal or parenteral routes. Nomenclature in the literature varies: the substance is also described by the sequence abbreviation TP-7 and by a Russian trade designation.
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. It was designed at the Institute of Molecular Genetics of the Russian Academy of Sciences as a structural analogue of tuftsin, a naturally occurring tetrapeptide fragment of the immunoglobulin heavy chain. The added Pro-Gly-Pro tail was intended to slow enzymatic degradation and extend biological activity. In Russia it is registered as an anxiolytic nasal preparation, while regulators elsewhere have not approved it for clinical use.
Proposed mechanisms centre on modulation of the GABAergic system, with reports of altered expression of genes related to GABA-A receptor subunits and changed monoamine turnover. Some studies describe inhibition of enkephalinase, the enzyme that degrades endogenous enkephalins, which may prolong opioid peptide signalling. Effects on brain-derived neurotrophic factor and on cytokine expression have also been reported. These findings come largely from animal models and small human studies, and the precise primary target remains unresolved.
UPMC Community Osteopathic located in Harrisburg, Pennsylvania UPMC West Shore located in Mechanicsburg, Pennsylvania UPMC Somerset, a 111-bed, general acute care community hospital located in Somerset, Pennsylvania UPMC Susquehanna which comprises five hospitals, including its tertiary flagship UPMC Williamsport, operates the additional four community hospitals in north central Pennsylvania and one outpatient emergency center: UPMC Cole located in Coudersport, Pennsylvania. It has 25 beds and its labor and delivery unit is scheduled to close in April 2025. UPMC Lock Haven (outpatient emergency center) located in Lock Haven, Pennsylvania UPMC Muncy located in Muncy, Pennsylvania UPMC Wellsboro located in Wellsboro, Pennsylvania UPMC Williamsport Divine Providence Campus located in Williamsport, Pennsylvania UPMC Washington, a 244-bed hospital located in Washington, Pennsylvania UPMC Greene, a 23-bed hospital of the former Washington Health System located in Waynesburg, Pennsylvania UPMC Western Maryland, a 200-bed hospital located in Cumberland, Maryland
p-Methoxyphenyl ether (PMP) – Removed by oxidation. Tert-butyl ethers (tBu) – Removed with anhydrous trifluoroacetic acid, hydrogen bromide in acetic acid, or 4 N hydrochloric acid Allyl — Removed with potassium tert‑butoxide DABCO in methanol, palladium on activated carbon, or diverse platinum complexes – conjoined with acid workup. Methyl ethers – Cleavage is by TMSI in dichloromethane or acetonitrile or chloroform. An alternative method to cleave methyl ethers is BBr3 in DCM. See Demethylation § In organic chemistry Tetrahydrofuran (THF) – Removed by acid.
Recently, Ke et al. developed a NanoVelcro chip that captures the CTCs from the blood samples. When blood is passed through the chip, the nanofibers coated with protein antibodies bind to the proteins expressed on the surface of cancer cells and act like Velcro to trap CTCs for analysis. The NanoVelcro CTC assays underwent three generations of development. The first generation NanoVelcro Chip was created for CTC enumeration for cancer prognosis, staging, and dynamic monitoring. The second generation NanoVelcro-LCM was developed for single-cell CTC isolation. The individually isolated CTCs can be subjected to single-CTC genotyping. The third generation Thermoresponsive Chip allowed for CTC purification. The nanofiber polymer brushes undergo temperature-dependent conformational changes to capture and release CTCs.
Sources: en.wikipedia.org
== Further reading == Extracellular matrix: review of its roles in acute and chronic wounds Usage of Extracellular Matrix from pigs to regrow human extremities Sound Medicine - Heart Tissue Regeneration – July 19 interview discussing ECM and its uses in cardiac tissue repair (requires MP3 playback).
== Materials and construction == A common hand tool, the crowbar is typically made of medium-carbon steel, possibly hardened on its ends. Commonly crowbars are forged from long steel stock, either hexagonal or sometimes cylindrical. Alternative designs may be forged with a rounded I-shaped cross-section shaft. Versions using relatively wide flat steel bar are often referred to as "utility" or "flat bars".
== Chemistry and animal toxicology == Buformin hydrochloride is a fine, white to slightly yellow, crystalline, odorless powder, with a weakly acidic bitter taste. Its melting point is 174 to 177 °C, it is a strong base, and is freely soluble in water, methanol and ethanol, but insoluble in chloroform and ether. The log octanol-water partition coefficient (log P) is -1.20E+00 and its water solubility is 7.46E+05 mg/L at 25 °C. Vapor pressure is 1.64E-04 mm Hg at 25 °C (EST); Henry's law constant is 8.14E-16 atm-m3/mole at 25 °C (EST). Its Atmospheric -OH rate constant is 1.60E-10 cm3/molecule-sec at 25 °C.
Sources: en.wikipedia.org
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.
Lyophilized powder is normally stored desiccated at -20 °C, protected from light and moisture. Powder kept under these conditions is generally stable for long periods. Solutions are less stable and are usually prepared immediately before use.
A purity value from one chromatographic method does not capture every possible impurity. Related peptides with similar retention behavior, counterions, and residual solvents may not appear in the same analysis. Independent testing with an orthogonal method provides stronger assurance of identity and content.
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.